Changing The Fuel Filter; Servicing The Blade-Drive System - Toro TurfMaster 22205TE Operator's Manual

Changing the Fuel Filter

Service Interval: Every 100 hours
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Close the fuel-shutoff valve
Figure 33
1. Fuel filter
4. Remove the fuel filter
line by loosening the tube clamps surrounding
the fuel filter.
5. Install a new fuel filter in the fuel line using the
tube clamps that you removed in step 4.
Servicing the Blade-Drive
System
Service Interval: After the first 5 hours
Every 50 hours—Remove debris from under
the belt cover.
Every 50 hours—Service the blade-drive
system.
1. Loosen the 2 screws on the belt-cover-access
panel and remove the panel
(Figure 33).
g019924
2. Fuel-shutoff valve
(Figure 33) from the fuel
(Figure 34).
1. Belt-tension spring
2. Adjusting bolt
3. Gap
4. Adjusting nut
2. Brush or blow out debris from the inside of the
belt cover and around all the parts.
3. Hold a feeler gauge set between 0.13 and 0.76
mm (0.005 and 0.03 inches) against the wall
and slide it down behind the belt tension spring;
refer to Figure
1. Read the Operator's
Manual before performing
any maintenance.
Note:
If there is a visible gap between the
gauge and the spring, tighten the adjusting bolt
and the nut until the feeler gauge barely slides
freely in and out of the gap
Important:
Do not overtighten the adjusting
bolt. This could damage the blade-drive belt.
4. Install the belt-cover-access panel.
21
Figure 34
5. Blade-drive belt
6. Wall
7. Belt cover
8. Belt-cover-access panel
35.
Figure 35
2. Check belt tension every
50 hours.
(Figure 34).
g208925
decal116-8528