Greasing The Mower Deck And Belt Idlers - Toro Z Master Professional 7000 Series Operator's Manual

Greasing the Mower Deck
and Belt Idlers
Service Interval: Every 25 hours—Grease the mower
deck and spindles.
Grease with No. 2 lithium or molybdenum grease.
Important:
Make sure that the cutting-unit
spindles are full of grease weekly.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the bottom bolt holding the mower-deck
curtain to the mower deck; refer to
the Mower-Deck Curtain (page
4. Remove the sheet-metal guard; refer to
Removing the Sheet-Metal Guard (page 42)
5. Remove the belt covers.
6. Grease the idler arm on the mower deck
54).
7. Grease the fittings on the push arms
or Figure 55).
Figure 54
Side Discharge Machines
8.
9.
Releasing
42).
(Figure
(Figure 54
10.
11.
g187362
44
Figure 55
Rear Discharge Machines
Grease the PTO-drive belt idler arm
Grease the pump belt idler arm
Figure 56
Install the sheet-metal guard.
Tighten the bottom bolt holding the mower-deck
curtain to the mower deck.
g194085
(Figure 56).
(Figure 56).
g007170