Lubrication; Greasing And Lubrication; Greasing The Mower Deck And Belt Idlers - Toro 74268 Operator's Manual

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug(s) before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.

Lubrication

Greasing and Lubrication

Lubricate the machine when shown on the Check
Service Reference Aid decal (Figure 38). Grease more
frequently when operating conditions are extremely
dusty or sandy.
Grease Type: General-purpose grease.
How to Grease
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Where to Add Grease
Lubricate the grease fittings as shown on the Check
Service Reference Aid decal (Figure 38).
Greasing the Mower Deck and
Belt Idlers
Service Interval: Every 25 hours—Grease the mower
deck and spindles.
Every 25 hours—Grease the mower
belt idler arm.
Every 25 hours—Grease the pump
belt idler arm.
Every 25 hours—Grease the drive
belt idler arm.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Important: Make sure cutting unit spindles are
full of grease weekly.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
33
Figure 38