Atex Marking; Warnings - Vokkero GUARDIAN EUROPE ATEX User Manual

VOKKERO GUARDIAN EUROPE ATEX - Add-on User Guide V1.0.0

ATEX MARKING

Uo ≤ 4.2V ; Io ≤ 63mA ; Po ≤ 0.260W ; Co ≤ 115μF ; Lo ≤ 2.25mH
Valid for VOKKERO GUARDIAN EUROPE ATEX: EN 60079-0:2012 ; A11:2013 ; EN 60079-11:2012
Read the instructions in the manual.
The safety of this product is only guaranteed when it is used in accordance with its purpose.
Only use of accessories in accordance with intrinsic safety parameters is permitted. This is under the responsibility of the user.
Similarly, only the Vokkero Guardian charger must be used to recharge Guardian products.
Only use of batteries specified by the manufacturer Vokkero is allowed, reference ARF8125BA.
Maintenance, such as modifying or dismantling the product, should only be carried out by qualified persons.
The ambient temperature range for charging the battery is from 0 to 40 ° C.
Please note: Do not install the equipment close to a heat source or in damp conditions.
Please note: When the equipment is open, do not carry out any operations other than the ones set out in this document.
Please note: Do not open the product as there is a risk of electrical shock.
Please note: For your own safety, you must ensure that the equipment is switched off before carrying out any work on it.
Please note: For your own safety, the power supply circuit must be SELV (Safety Extra Low Voltage) and must be from
limited power sources.
The product must be equipped with a switching mechanism so that the power can be cut. This must be close to the equipment. Any electrical
connection of the product must be equipped with a protection device against voltage spikes and short-circuits.
ATEX STANDARD
All users of the product VOKKERO GUARDIAN ATEX must be trained in accordance with ATEX standards
as defined by EN60079-14.
ATEX II 2 G D
Ex ib IIC T4 Gb
Ex ib IIIC T135°C Db
-10°C < Ta < +45°C

WARNINGS

EN
13 / 16