Table of Contents
Advertisement
190
If Something Goes Wrong
Resolving a hardware conflict
The operating system displays a message that you may
safely remove the card.
3
Remove the card from the slot.
The system does not recognize your PC Card or
PCMCIA socket controller.
1
Make sure the computer is not in Standby mode. For
more information, see
2
Turn off the computer.
3
Connect the AC adapter and power cable.
4
Keep the computer plugged in for about three hours with
the power turned off.
The problem may also be caused by a conflict with any
additional memory in your system.
Removing a malfunctioning card and reinstalling it can
correct many problems. For more information, see
PC Cards" on page
A PC Card error occurs.
Reinsert the card to make sure it is properly connected.
If the card is attached to an external device, check that the
connection is secure.
Refer to the card's documentation, which should contain a
troubleshooting section.
Never swap modules when the computer is in Hibernation or
Standby mode. This is known as "warm swapping" and is not
supported with this computer For more information on
Hibernation and Standby modes,
on page 92
and
"Stand By command" on page 93
166.
see."Hibernation command"
"Using Stand by" on page
98.
"Inserting
Advertisement
Table of Contents
