Ozone Footpads and Straps V2 How To Set Up And Adjust

Footpads and

straps V2

H o w t o s e t u p a n d a d j u s t

slide tHe strap tongues up tHrougH tHe

footpad baseplate slot froM tHe underside

undo tHe strap velcro and reMove tHe tongues.

Make sure tHe tongue angle faces forward, towards tHe toe side of tHe footpad.

NOTE: tHere is no left or rigHt tongue, all tongues are tHe saMe.

Table of Contents

Do you have a question about the Footpads and Straps V2 and is the answer not in the manual?

Page 1 Footpads and straps V2 H o w t o s e t u p a n d a d j u s t undo tHe strap velcro and reMove tHe tongues. Make sure tHe tongue angle faces forward, towards tHe toe side of tHe footpad. slide tHe strap tongues up tHrougH tHe NOTE: tHere is no left or rigHt tongue, all tongues are tHe saMe.
Page 2 tHe top velcro strap end faces towards tHe feed tHe velcro straps tHrougH tHe tongue slot wHile inserting tHe tongues into tHe strap on eacH side. centre of tHe board. position tHe strap tongues at tHe Middle line up tHe baseplate Holes witH tHe board inserts you can cHoose between five stance angles, tHe baseplate setting.
Page 3 after first use and periodically we recoMMend to cHeck all screws and re-tigHten if necessary. sTaNdard TONguE pOsiTiON slidE TONguE backwards slidE TONguE fOrwards slowly undo tHe baseplate screws (don’t unscrew all eacH strap tongue Has tHree positions in tHe for a furtHer custoMised fit you can try tHe tHe way) to allow clearance for tHe strap tongue to baseplate, wHicH allows for nine different strap...