Toshiba A660-BT2N22 User Manual page 57

(Sample Illustration) Inserting the memory module into the slot
NOTE
For this model, Slot A is the bottom slot. Slot B is the top slot. If only
one memory module is to be installed, it must be installed in Slot A.
14 Replace the memory module slot cover and secure it using the
screw.
15 Re-insert the main battery. For more information on inserting
the main battery, see
16 Turn the computer right side up. Make sure to remove the soft
cloth from the work surface before restarting the computer.
Always make sure your computer and AC adaptor have adequate
ventilation and are protected from overheating when the power is turned
on or when an AC adaptor is connected to a power outlet (even if your
computer is in Sleep mode). In this condition, observe the following:
❖
❖
❖
❖
Overheating your computer or AC adaptor could cause system
failure, computer or AC adaptor damage or a fire, possibly resulting
in serious injury.
Adding memory (optional)
Back of computer
"Inserting a charged battery" on page
Never cover your computer or AC adaptor with any object.
Never place your computer or AC adaptor near a heat source,
such as an electric blanket or heater.
Never cover or block the air vents including those located at the
base of the computer.
Always operate your computer on a hard flat surface. Using your
computer on a carpet or other soft material can block the vents
located at the base of the computer.
Getting Started
Slot B
Slot A
57
131.