Table of Contents
Advertisement
112
Learning the Basics
Powering down the computer
Going into Standby mode more quickly
You can also configure the computer to enter into Standby
mode by either pressing the power button or closing the
display panel. You can also specify an amount of time after
which the computer automatically enters into Standby mode.
To use any of these methods, you first need to enable them in
Toshiba's Power Saver utility.
1
Open the Start menu, click Control Panel, then
Performance and Maintenance.
2
Click the Toshiba Power Saver icon.
3
Click the Setup Action tab.
4
Select Stand by for the options you want.
❖
❖
5
Click Apply.
6
Click OK.
NOTE
When I press the power button
Set this option to Standby to put the computer into
Standby mode when you press the power button.
When I close the lid
Set this option to Standby to put the computer into
Standby mode when you close the display panel.
For more information about the Power Saver utility, see
"Power Saver" on page
230.
Advertisement
Table of Contents
