HSS Hire 80880 Quick Start Manual

Span Access Platform
Platform
Support
Tube Fixing
Middle Guard Rail
Rung
Brace Hook
Middle
Guard
Pin
Rail
Swing
Braces
Lift
OFF
ON
Brake
ALWAYS brake ALL wheel castors before climbing
onto the platform.
ONLY enter and exit the platform by climbing on
at either end.
NEVER climb onto the unit without having the
clearance brace and clearance brace diagonals
fitted.
NEVER move the unit with people on the platform.
USE on firm, flat level surfaces only.
DO NOT exceed the safe working load – 225kg.

EQUIPMENT CARE

Never push the equipment beyond its design
limits. If it will not do what you want with reasonable
ease and speed, assume you have the wrong tool for the
job. Contact your local HSS Hire Shop for advice.
Keep the equipment clean – you will find this less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
Immediately wash off any spills of paint, or other
fluids that could mark or stain the equipment.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.

FINISHING OFF

Disassemble the Platform by reversing the instructions in
Getting Started, collect all the components together
and give the unit a final clean up ready for return,
to your local HSS Hire Shop.
Table of Components
Component
End Frame (1.8m)
Platform (2.5m)
Platform
Toeboard set (2.5m)
Toeboard
Guard rail frame (1.0m)
Guard Rail Brace (2.2m)
...any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
Fax: 020 8687 5001
©HSS Hire Service Group Plc 2002 No. 438/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
Quantity
2
1
1
2
4
Contact your local
0845 728 2828
address below
Operating & Safety Guide 438
Span Access
Platform
Easy to assemble, easy to carry 1.9m
access platform that can span over
obstacles up to 1.5m high.
Code 80880