Measure Resistance; Test Diodes And Continuity - Aneng SZ18 User Manual

*Do not measure current that exceeds the extremes
as indicated in the Specifications.
*Use the AmA Terminal when you are measuring an
unknown current. Then switch to the μA Terminal
if necessary.
*Do not input voltage at this setting.

Measure Resistance

1. Connect the black test lead to the COM Terminal
and the test lead to the
2. Turn the rotary to
Resistance Mode. The screen will show "
3. Touch the probes to the desired test points of
the circuit to measure the resistance;
4. Read the measured resistance on the display.
*Disconnect circuit power and discharge
capacitors before you test resistance.
*Do not input voltage at this setting.

Test Diodes and Continuity

1. Connect the black test lead to the COM Terminal and
the red lead to the
2. Turn the rotary to
continuity Mode;
3. To test continuity, touch the probes to the desired
test points of the circuit. The built-in beeper will
beep when there is a short circuit;
Terminal;
, press "SELECT" to the
Terminal;
, press "SELECT" to the
10
";
all