For Household Use Only - Hamilton Beach HB-VC32W Owner's Manual

To access and remove, first rotate the cover counterclockwise and lift straight up and
off to expose the filter (fig 6/6).
fig. 6/6
To remove the filter, grasp with your fingers and pull straight up and out.
Wash the foam filter in warm, mild, soapy water. Rinse in clean, cold water and let
completely dry for 24 hours before replacing.
Refit the filter by pushing back into the holder. Note the coarser black face of the filter
must be at the bottom. It is recommended to clean this filter every other week or
sooner if required.
Refit the cover and rotate clockwise to lock in place. Refit the dust container to the
vacuum cleaner.
IMPORTANT: Cleaning the filters regularly improves the vacuuming performance. Make
sure that all the filters are replaced back into the vacuum cleaner before using. This vacuum
cleaner is intended for household use only and not for commercial or industrial use. Store
the vacuum in a cool dry area. Any other service should be performed by an authorized
service center.
IIMPORTANT: The motor is equipped with a thermal protector. If, for any reason, the
vacuum cleaner should overheat, the thermal protector will automatically turn the unit off.
Should this occur, turn off the switch and unplug the vacuum cleaner from the electrical
outlet. Remove the dust container and empty it. Clean the filters. Allow the vacuum cleaner
to cool for approximately one (1) hour. To restart, plug into an electrical outlet and switch
back on..

FOR HOUSEHOLD USE ONLY

10