Advertisement
Quick Links
Turnigy TrackStar 10th Waterproof Sensored ESC Manual
Transmitter Calibration:
Connect the ESC, battery and signal line, and then press the switch button for about 3 seconds, the blue LED
long bright solid, the ESC is into the transmitter calibration mode:
1. Push the transmitter stick to maximum forward position, the blue LED will flash and then the red LED lights
will go solid.
2. Then push the throttle stick to max brake position, the red LED will start flashing and then the blue and red
LED lights.
3. Return the throttle stick to neutral position, the red and blue LED will flash, then a long light for about 2
seconds, the red and blue LED light will flash twice. The transmitter calibration is complete.
Normal Operation:
Blue and Red LEDs on for Forward with pause then Reverse
Blue LED on for Forward Only
As the battery voltage gets low there is a low voltage warning. The
Red LED will blink. As Temperature gets to warning point, Blue LED
will blink.
Boost timing set to zero, Blue LED flashing.
Sensored alarm, the red and blue LED lights flash, ESC does not work.
Default Settings:
Operation Mode
Initial Braking
Drag Brake
Brake Strength
Voltage Cut Off
Punch Profile
Neutral DeadBand -
Boost Timing
Reverse Speed
Drive Frequency
Brake Frequency
Temperature Set
-
For/Rev/Brake
-
= Drag Brake
-
5%
-
80%
-
3.2V/cell
-
Level 7
3%
-
0 deg
-
75%
-
8KHz
-
1KHz
-
On
Advertisement
Related Manuals for Turnigy TrackStar
Summary of Contents for Turnigy TrackStar
- Page 1 Turnigy TrackStar 10th Waterproof Sensored ESC Manual Transmitter Calibration: Connect the ESC, battery and signal line, and then press the switch button for about 3 seconds, the blue LED long bright solid, the ESC is into the transmitter calibration mode: 1.
- Page 2 Programming BOX set flow Chart： PROGRAM BOX V2.1 Press any key TrackStar Tburbo TrackStar 70A Ver: 14268101 For/Brake、For/Rev/Brake Operation MOde =Drag Brake、10%、20%、30%、40% Initial Brake 0%、5%、10%、15%、20%、25%、30%、35%、40% Drag Brake 50%、60%、75%、80%、85%、90%、100% Brake Strength None、 3.0V/cell、 3.2V/cell、3.4V/cell、3.5V/cell Voltage Cut-Off Level 1、Level 2、Level 3、Level 4、Level 5、Level 6、Level 7、Level 8、Level 9 Punch Profile 1%、3%、5%、8%...
Need help?
Do you have a question about the TrackStar and is the answer not in the manual?
Questions and answers