Programming / Configuration; Pc Programming; Npu - Neat Programming Unit; Ior Programmer, Start Screen - Neat INKA Technical Handbook

2 Programming / Configuration

Configuration of the units in the IOR family can be done in two ways:
•
Programming from a computer with NEAT Programming Unit (NPU)
•
Mounting or removing jumpers on the PCB inside the unit
PC programming using the NPU is described in section 2.1. Jumper configuration is described in
section 2.2.

2.1 PC programming

2.1.1 NPU – NEAT Programming Unit
2.1.1.1 Installation of the program
The NPU is connected between the unit to be configured (INKA, IOR, REPO or LINK) and the USB
port of a computer. When you have received your NPU, follow the steps below.
IMPORTANT! Do not connect the NPU until you have finished the installation of the program.
•
Download the software and installation manual from www.neatelectronics.com.
•
Install the program by using the installation manual before connecting the NPU
2.1.1.2 Using the NPU
To connect the NPU, follow the instructions below:
•
Connect the AC adapter to the NPU
•
Connect the NPU to the USB port on the computer by the USB cable
•
Connect the NPU to DC connector on the bottom side of INKA, IOR, REPO or LINK.
•
Switch on the unit to be configured
You are now ready to read and write all parameters that are given in the PC program.

2.1.2 IOR Programmer, Start Screen

In the Windows start-menu, you find the IOR Programmer software under Programs / NEAT. The first
thing you see when you start the program is the start screen displayed below. Select the product
model that you want to configure – INKA, IOR, REPO or LINK – by clicking the corresponding push
button.
Technical Handbook for the IOR Family (firmware v20.x), document number NE41 06007-02 v1.0
INKA, IOR, REPO & LINK
13