Quick Start; Plug Z-Pi 7 Onto A Host Controller - Aeotec Z-Pi 7 Quick Start Manual

For more information about Z-Wave technology, devices, white papers etc. please refer
to www.z-wave.info.

Quick start.

The following will step you through using Z-Pi 7 when it is attached to a host, such as a
PC,as your primary Z-Wave controller. Please ensure that your automation software
supports the Z-Wave Serial Bridge API.
Please make sure the host controller is pre-installed; this includes any drivers that the
corresponding operating system may need. In most cases, the host controller automatically
installs the required driver. If not, the driver can be downloaded from www.silabs.com part
CP2102N.
Expanded quick start steps are available at support.aeotec.com/zp7.
1. Plug Z-Pi 7 onto a host controller (that can be any Raspberry Pi, Orange Pi etc. with
GPIO's).
Raspberry Pi