Aeotec Z-Pi 7 Quick Start Manual

Table of Contents

Download this manual

Z-Pi 7

SKU: AEOEZWA025

Used in this guide.

Artículos utilizados en este manual / Utilisé dans ce guide / In dieser Gebrauchsanweisung

verwendete Bezeichnungen / Usato in questa guida / Gebruikt in deze handleiding / Används

i den här handboken.

Important safety information.

Please read this and the online guide(s) at support.aeotec.com/zp7 carefully. Failure to

follow the recommendations set forth by Aeotec Limited may be dangerous or cause a

violation of the law. The manufacturer, importer, distributor, and/or reseller will not be held

responsible for any loss or damage resulting from not following any instruction in this guide

or in other materials.

is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet

locations.

What is Z-Wave™?

Z-Wave is the international wireless protocol for communication in the Smart Home. This device

is suited for use in the region mentioned in the Quickstart section.

Z-Wave ensures a reliable communication by reconfirming every message (two-way

communication) and every mains powered node can act as a repeater for other nodes (meshed

network) in case the receiver is not in direct wireless range of the transmitter.

This device and every other certified Z-Wave device can be used together with any other

certified Z-Wave device regardless of brand and origin as long as both are suited for the

same frequency range.

If a device supports secure communication it will communicate with other devices secure as

long as this device provides the same or a higher level of security. Otherwise it will automatically

turn into a lower level of security to maintain backward compatibility.

Table of Contents

Do you have a question about the Z-Pi 7 and is the answer not in the manual?

Page 1 Please read this and the online guide(s) at support.aeotec.com/zp7 carefully. Failure to follow the recommendations set forth by Aeotec Limited may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting from not following any instruction in this guide or in other materials.
Page 2 Quick start. The following will step you through using Z-Pi 7 when it is attached to a host, such as a PC,as your primary Z-Wave controller. Please ensure that your automation software supports the Z-Wave Serial Bridge API.
Page 3 Follow that software’s instructions for connecting a Z-Wave adapter. Select the COM or the virtual port Z-Pi 7 is associated with. In most cases, any devices already paired with Z-Pi 7 network will automatically show up in the software’s interface.

Aeoezwa025