What To Do If - Electrolux SANTO 76308 KA User Manual

14

What to do if...

WHAT TO DO IF...
WARNING!
Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or competent person must do the troubleshooting that is not
in this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
Problem
The appliance is noisy
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The Pilot light flashes.
The compressor operates
continually.
The compressor does not
start immediately after
pressing theTURBO
COOLMATIC button, or
after changing the tem-
perature.
Possible cause
The appliance is not supported
properly
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket correct-
ly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The appliance is not working
properly.
The temperature is not set cor-
rectly.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The compressor starts after a pe-
riod of time.
Solution
Check if the appliance stands sta-
ble (all the four feet should be
on the floor)
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Contact a qualified electrician.
Set a higher temperature.
Do not keep the door open lon-
ger than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.