Panasonic WX-SA250P Operating Instructions Manual page 16

Installation
⿟ In the following case, contact a retailer beforehand to confirm suitability of the
environment for use with the antenna:
⿠ Using the antenna on a wagon trolley
⿟ As the antenna uses the same frequency (1.9 GHz) as other DECT devices such as
cordless phones, the maximum number of usable microphones may be limited.
Power
⿟ The antenna does not have a power switch. Unplug the LAN cable to turn OFF the
antenna. If the cable cannot easily be unplugged because of the way in which the
antenna is installed, unplug the power cable of the receiver connected to the antenna.
⿟ Make sure that all equipment is powered OFF before installing it.
⿟ Make sure that the equipment is working before installing it.
Important
Connect the antenna with the receiver and supply power to it. Then
confirm that the microphone audio is output from the speaker connected
to the receiver.
Static electricity
⿟ Before installing the antenna, discharge yourself by touching a grounded metal object in
order to avoid damage caused by static electricity buildup.
Tightening screws
⿟ Tighten screws straight up. After tightening the screws, make visual confirmation that
they are straight and well-tightened.
⿟ Do not use impact screwdrivers or electric screwdrivers, as even the ones with clutches
make it difficult to control the torque, and risk damaging the mounting unit.
Avoid subjecting the antenna to shocks
⿟ Protect the antenna from strong hits or shocks. These may cause damage to the
antenna.
Adding antennas
⿟ Before adding new antennas, power OFF the receiver. If you add an antenna to a turned
on receiver, the new antenna will not be powered and it will be not usable.
LAN cable
⿟ LAN cable not included with the antenna.
Use a Cat 5 (or Cat 5e or Cat 6) straight network LAN cable. There is a maximum cable
length depending on the connection method. See "Connections" (page 24) for details.
16