09. July 2008 Indigo Release Notes Introduction This document includes notes for software installation, new features and changes, and other information specific to INDIGO Release 1.2.19 software. Note Please read this Release Notes before updating the software! New Features and Changes •...
Indigo’s HD-SDI input. Acappella If the router output cannot be synchronized after switching to a non-sync source, the internal scalers of the Indigo needs to be reset by temporary changing the HiRes input source, e.g. from HD-SDI to VGA or DVI. Acappella Transitioning Acappella sources faster than two seconds apart will result in transition command being skipped.
• The total used number of dynamics and limiter channels available at the same time is limited to six. • The side chain inputs are limited to four at a time. An error message appears if more dynamics or limiter are activated. Figure 1. Message Example INDIGO — Release Notes...
1. PC with Compact Flash card reader. 2. CF card with min. 128MB capacity which is formatted for FAT file system. The CF card of your INDIGO can be overwritten, but you may want to keep the old software. Procedure 1.
Page 9
7. Wait until the copy process is completed. Then remove the CF card. 8. While your INDIGO is still turned off, insert the CF card containing the new software into the slot on the upper side of the printed circuit board.
Version 1.2.19 More Information Please refer to the INDIGO AV Mixer User Manual (section 10/ Mainte- nance) for more information. Contacting Grass Valley Customer Service Contact Grass Valley Customer Service if you have questions or encounter any problems: • North America: 1-800-547-8949 or 1-530-478-4148 •...
It can be done at any time. Upgrade Procedure Connect 2 DVI cables from the Indigo DVI outputs to the Indigo DVI inputs and power up the unit. As soon as the Indigo Menu appears the update process is finished.