Advertisement
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
•
Check if the voltage indicated on the rating plate of the appliance corresponds to
the local mains voltage before you connect the appliance.
•
Use this heater only as instructed in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
•
A worn mains socket may result in over-heating of the plug and socket. If this
occurs consult a qualified electrician.
•
Arrange mains cord away from any traffic area and where it will not become a
hazard to users and ensure that the supply cord is kept away from heat or sharp
edges that could cause damage.
•
The heater must not be located immediately below an electrical socket-outlet.
•
Do not use this heater with a timer or any device that switches the power on
automatically, as a fire risk exists should the heater be covered or place incorrectly.
•
In case of improper use, there is a risk of electrical shock and/or fire hazard.
•
Do not try to repair the appliance by yourself. Please contact with the service agent
or a suitably qualified electrician for maintenance.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience or knowledge. They
should be given supervision and instruction in the use of the appliance by a person
responsible for their safety.
•
The casing of the appliance can become extremely hot during operation. To avoid
burns, do not let bare skin touch hot surfaces. Use the handles when moving this
heater.
•
Extreme caution is necessary when used by or near children or vulnerable people.
•
This heater is not intended for use near swimming pools, hot tubs and similar
locations. Never locate the heater where it may fall into any water container.
•
To prevent a possible fire or electric shock, do not block or allow foreign objects to
enter any air intakes or ventilation slots in any manner.
•
Do not use floor standing heaters on soft or uneven surfaces where instability may
be caused.
•
Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner.
•
Keep combustible materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 1.0m from the front of the heater.
•
Do not use in areas where gasoline, paint, or flammable liquids are used or stored.
•
Remove the plug from the power outlet and wait until the appliance is completely
cooled off before cleaning or putting into storage.
•
To disconnect heater you should turn the controls off then remove plug from outlet.
•
Always unplug heater when not in use.
•
In order to avoid overheating, do not cover the heater.
•
Never leave this heater unattended.
•
This heater is for indoor use only.
WHAT'S INCLUDED
•
Heater unit
•
User manual
•
Feet - 2 off
•
Attaching screws
2
ASSEMBLY
•
Before using this appliance, it must have the supplied feet fitted.
WARNING: Do not operate the heater without the feet fitted.
•
Turn the heater body upside-down on a scratch-free and stable surface.
•
Be careful to prevent damage to the cosmetic finish or your floor surfacing.
•
Attach the feet to the base of the heater using the screws provided, taking care to
ensure that they are located correctly on the bottom of the heater.
OPERATION
NOTE: When the appliance is turned on for the first time, it may release a slight, odour
or smoke. This odour or smoke is a normal occurrence caused by the initial heating of
the internal heating elements and should not occur again.
•
The control switch positions are:
0
- Off
750W
- Low Heat
1250W - Medium Heat
Both
- High Heat
•
Check that the heat control switches are both set
to OFF position before plugging the heater into
the mains supply.
•
For greater economy, use the high heat setting
initially and then switch to a lower heat setting.
•
Rotate the thermostat control clockwise to
increase the temperature that the heater will
switch off when reached.
•
When the room temperature falls the
NOTE: if the thermostat is set to a high level, if the heat setting is only on low, the
heater will remain on constantly.
heater will turn on again.
3
Advertisement
