Bicom Systems Grandstream GXP-2160 User Manual page 6

The following topics are covered:
Hostname or IP Address
DNS SRV
Registering your device
A) Line configuration from devices web interface.
To access the web interface of your Grandstream phone, first you must know it's IP address on
your network.
To find the IP address of your device please:
Press the Home button.
Go to Status and press the Select button.
Go to Network status and press the Select button.
IP address is displayed under IPv4: e.g. 192.168.8.198
NOTE: Depending on your Grandstream device and its firmware, web interface settings may
vary.
Once you have entered the IP address a log in menu will pop up, the user name is: admin and
the password is: admin.
After you log in, under VIEWS you should select Simple Setup.
Then use the toggling show/hide button to reveal the content of the SIP Server group.
Enter your PBXware IP address into Address field.
Enter 5060 into Port field.
After this has been completed you should then use the toggling show/hide button to reveal the
content of the IP Line Identification
Enter extension into the Address field.
Enter extension into the Authentication User ID field.
Enter extension secret into the Authentication Password field.
Press Save button to preserve changes. Your phone should register after couple of seconds, if
not, please reboot your phone.
B) Line configuration on device
Press the Home button on your phone.
Go to Phone and press the Select button.
Press Select on SIP.
press Select on Account 1.
enter PBXware IP address e.g. 192.168.8.185 in SIP proxy and then press the Save button.