Fault Finding - Eico MFG 185 Instructions For Use Manual

GB

Fault finding

Fault
The control lamp is
not lit.
Water collects on
the shelves.
Vibration or bother-
some noise.
Compressor runs
continuously.
Temperature in cabi-
net too high.
Ice formation on
evaporator.
Possible cause
The appliance is switched off.
Power failure; the fuse is blown;
the appliance is not plugged in
correctly.
The defrost water drain is
blocked.
The appliance is not level.
The appliance is resting against
other elements.
Temperature setting too low.
High room temperature.
Temperature setting too high.
The cabinet has recently been
filled with unchilled bottles.
Door is open.
Remedy
Press the on/off switch.
Check that power is connected.
Reset the fuse.
Clean the defrost water channel
and the drain hole on the rear
wall of the cabinet.
Level the appliance using a spirit
level.
Move the appliance away from
other elements or appliances it is
in contact with.
Raise the temperature setting.
Ensure adequate ventilation.
Lower the temperature setting.
Distribute items within the cabi-
net to improve air circulation.
Close the door
10