Drinking water filter Inhalt General information ..................4 Scope of delivery .....................4 Intended Use ....................5 Requirement for the installation site ...............5 Installation .......................6 Start-up ......................7 Pressure reducer ....................7 Maintenance ....................8 Backwash ......................8 Technical specifications ..................9 Dimensions ....................10-11 magnetic ...einfach besser...
General information The magnetic drinking water filter must be installed by an approved specialist in the plumbing and heating industry. Inspect the device for transport damage immediately upon receipt. The drinking water filter must be protected against frost and must not to be installed in the immediate vicinity of heat sources with high radiation temperature.
Intended use The magnetic drinking water filter is intended for the filtration of drinking wa- ter. It protects water pipes from malfunctions and corrosion damage from foreign objects such as rust, sand or chips. The filter cannot be used with chemical-treated circulating water. It is not suit- able for oils, greases, solvents, soaps and other lubricants, or for removing water-soluble substances.
Installation Please note the installation diagram for installation. Firmly connect the fil- ter with the connection to the threaded socket on the water supply network. Use the enclosed nuts and screw connections for this. The arrow stamped on the rotary connection (Fig. 1 + 2) must point in the direction of the water flow.
Start-up After the magnetic drinking water filter has been installed, you can put the backwash filter into operation by slowly opening the shut-off valves. The pipe- line must then be vented via the nearest connection. The magnetic drinking water filter must be checked for leaks after installation and after every main- tenance.
Maintenance Maintenance includes periodic backwashing to remove floating dirt particles, silt, sand, etc. from the filter cartridge. It is recommended to backwash at least once a month. The arrow in the month bar signals the next backwash period and must be adjusted to the next date after backwashing.
Flow rate at Dp 0.2 bar m³ Flow rate at Dp 0.5 bar m³ Nominal pressure PN Pressure area Connection nominal size Water/ambient temperature, max °C Weight in kg 2.77 3.02 3.94 3.97 Mesh size in µm DVGW registration number DVGW requested magnetic ...einfach besser...
Dimensions Backwash filter (TWF-1) 1“ 1 1/4“ A Total height [mm] Installation height up to the middle of [mm] the connection Installation depth up to the middle of [mm] the connection Installation length with/without screw [mm] 183 / 110 188 / 110 connection...
Page 11
Domestic water sta- tion (HWS-1) 1“ 1 1/4“ A Total height [mm] Installation height up to the middle of [mm] the connection Installation depth up to the middle of [mm] the connection Installation length with/without screw [mm] 215 / 112...
Page 12
GmbH & Co. KG Am Richtbach 5 D-74547 Untermünkheim Tel. +49 7944 94199-0 Fax +49 7944 94199-19 info@magnetic-online.de www.magnetic-online.de Managing partner: Michael Bader VAT ID No.: DE 255 018 730 Commercial register: HRA 571362 Reg. Ger. Stuttgart www.magnetic-online.de...
Need help?
Do you have a question about the HWS-1 and is the answer not in the manual?
Questions and answers