Panasonic WX-ST200P Operating Instructions Manual page 36

Troubleshooting
Phenomenon
The [PWR] indicator
blinks green and I
cannot use the
microphone
Audio from the
microphone unit is not
transmitted
I cannot charge the
microphone
(The [CHG] indicator
stays off)
I cannot charge the
microphone
(The [CHG] indicator
only stays on for a few
minutes)
36
Cause/measure
⿟ You cannot use the microphone because there
is another active microphone paired to the
same channel.
¨ Stop using the other microphone paired to
¨
the same channel.
⿟ The microphone may be almost outside of the
antenna range.
¨ Move the microphone inside the antenna
¨
range.
⿟ Is an external device connected to the [AUDIO
IN] connector?
¨ When an external device is connected, even
¨
if it is turned OFF, it will take precedence
over the microphone unit, which will stop
audio transmission from the microphone unit.
Disconnect the plug from the [AUDIO IN]
connector.
⿟ Is the volume on the receiver, connected
amplifier, etc. high enough?
¨ Adjust the volume with the volume
¨
adjustment knob.
⿟ Is the microphone properly inserted into the
charger?
¨ Make sure that the microphone is properly
¨
inserted into the charger.
⿟ Is the battery already charged?
¨ The battery may already be fully charged.
¨
Take the microphone out of the charger and
use it as normal.
Reference
page
13
13
29
―
32
32