Subscribe to Our Youtube Channel
Related Manuals for CommScope OneCell RP Series
Summary of Contents for CommScope OneCell RP Series
- Page 1 ® OneCell Outdoor Radio Point Installation Document Number: 913032 Document Revision: 1.04 Date: February 2016...
-
Page 2: What's In The Box
What’s in the box The outdoor Radio Point (RP) ships with the following hardware: • Radio Point with mounting plate and brackets attached • Four mounting screws (M5 x 10mm) • RJ45, IP67 connector • Two N-type antenna couplers Mounting the Radio Point (RP) on a pole requires the following hardware provided by the system integrator: •... -
Page 3: Pole Mount Installation
Pole mount installation NOTE The minimum pole diameter requirement is 4'' (102mm). Slide the adjustable clamp through the slots on each RP mounting bracket on the RP plate. Slide adjustable clamp end through slots... - Page 4 Wrap each clamp around the pole and tighten the clamp screw to secure the RP to the pole. Insert two screws into the upper holes on opposite sides of the RP as shown in the drawing below. Insert screws into the holes called out –...
- Page 5 Hang the RP to the mounting bracket using the installed screws. Align holes at bottom location of bracket and install two additional screws. Tighten all four screws.
- Page 6 Insert and tighten the bottom screws through the plate hole into both sides of the Connect the antenna couplers on the top of the RP. Connect the Ethernet cable RJ45 end to the bottom of the RP. Antenna couplers Bottom screw Ethernet connector RJ45 Installation complete.
-
Page 7: Wall Mount Installation
Wall mount installation Remove the brackets from the back of the mounting plate. - Page 8 Drill four holes in the wall using the mounting plate to determine the hole locations. Mount the backplate on the wall with four molly screws.
- Page 9 Insert two screws into the upper holes on opposite sides of the RP as shown in the drawing below. Insert screws into the holes called out – one on each side. Attach the RP to the mounting plate. Tighten the screws on the RP.
- Page 10 Insert and tighten the bottom screws through the plate hole into both sides of the Connect the antenna couplers on the top of the RP. Connect the Ethernet cable RJ45 end to the bottom of the RP. Antenna couplers Bottom screw Ethernet connector RJ45 Installation complete.
Need help?
Do you have a question about the OneCell RP Series and is the answer not in the manual?
Questions and answers