Advertisement
Sunwood Bottom Bar Installation Guide
How To Install Bottom Bar On Ready Made Sunwood Blinds
1. Install your wooden blind following the instructions enclosed in the box. At this stage there may
be extra slats resting on the window sill.
2. Underneath the bottom slat undo the knots in the single cords running through the middle of the
slats.
3. Slide out any extra slats which are not required.
4. Slide the thicker bottom bar through the space in the ladder tape underneath the last slat.
Advertisement
Table of Contents
Related Manuals for Blinds Direct Sunwood Bottom Bar
Summary of Contents for Blinds Direct Sunwood Bottom Bar
- Page 1 Sunwood Bottom Bar Installation Guide How To Install Bottom Bar On Ready Made Sunwood Blinds 1. Install your wooden blind following the instructions enclosed in the box. At this stage there may be extra slats resting on the window sill.
- Page 2 5. Push the plastic bungs out of the bottom bar. 6. Pass the raise / lower single strand cord (the cord which runs through the centre of the slats) through the hole in the bottom bar. Now pass the raise / lower cord through the middle of the plastic bung then back through the bung again at the other side of the brass bar inside.
Need help?
Do you have a question about the Sunwood Bottom Bar and is the answer not in the manual?
Questions and answers