Table of Contents
Advertisement
The Finish Rake on the SR1 can be used as an independent feature for use on jobs to
distribute loose material. To use the finish rake as an independent feature, follow these
procedures.
Smoothing out material with the Finish Rake:
1. With the SR1 attached to the Skid Steer, transport the SR1 to an area where the
material has been broken up using the scarifiers on the SR1.
2. Lift the SR1 using the boom and tilt the SR1 so that the finish rake is angled 20 to
30-degrees.
3. Lower the SR1 down so that the finish rake rest firmly on the surface. For areas
with uneven surfaces the boom may need to be lowered or raised to prevent
excess material from building up, or to allow for material to continue to be moved.
4. Slowly back up with the Skid Steer allowing the finish rake to move the material.
5. To give the job a finished look, slowly raise the boom as the Skid Steer moves
backward to allow the material to feather out over an area.
Pushing Material with the Finish Rake:
**Note to Operator: The SR1 can be used to push material into an area. Always ensure
the material has been loosened prior to pushing material, and never push material into
an area where obstacles may be hidden, or out of operator view to prevent damage to
the SR1 or property.
1. With the SR1 attached to the Skid Steer, transport the SR1 to an area where the
material has been broken up using the scarifiers on the SR1.
2. Lift the SR1 using the boom and tilt the SR1 so that the finish rake is angled at 20
to 30-degrees.
3. Lower the SR1 down so that the finish rake rests firmly on the surface of the
material.
4. Slowly push forward allowing the material to move forward with the SR1.
5. Once the material is moved into the area where it is needed, raise the boom and
tilt the SR1 forward to allow the excess material to be deposited into the area.
Check hardware daily to ensure that nuts and bolts are tight, and that pins are properly
secured. If any hardware is found to be damaged replace hardware prior to operating the
SR1.
USING THE SR1 FINISH RAKE
MAINTENANCE
© Copyright 2018 ABI Attachments, INC
7
Advertisement
Table of Contents
