Advertisement
Quick Links
DRYTAG RH INSTALLATION INSTRUCTIONS
Setting Up Your DryTAG RH
1. Using the two screws near the battery pull tab using a Phillips #1.
2. Remove the battery pull tab and discard.
3. Tighten the two screws.
4. Follow instructions on TS- 1131 to add the DryTAG RH to DryLINK.
5. After installation onto equipment (see below), check that equipment shows as "on" within
DryLINK.
Installing Onto Equipment
General
The DryTAG RH can be mounted with cable ties or screws. We recommend using cable ties.
|
USEPHOENIX.COM
800-533-7533
Advertisement
Related Manuals for Phoenix DryTAG RH
Summary of Contents for Phoenix DryTAG RH
- Page 1 4. Follow instructions on TS- 1131 to add the DryTAG RH to DryLINK. 5. After installation onto equipment (see below), check that equipment shows as “on” within DryLINK. Installing Onto Equipment General The DryTAG RH can be mounted with cable ties or screws. We recommend using cable ties. USEPHOENIX.COM 800-533-7533...
-
Page 2: Mounting Instructions
DRYTAG RH MOUNTING INSTRUCTIONS Mounting DryTAG RH on a Phoenix R250 STEP MOUNTING INSTRUCTIONS Ensure the dehumidifier is unplugged. Remove lay-flat duct ring. Using a T20 Torx screwdriver, remove the 4 screws securing the outlet grill in place. Remove grill. - Page 3 DRYTAG RH MOUNTING INSTRUCTIONS Mounting DryTAG RH on a Phoenix R250 STEP MOUNTING INSTRUCTIONS Place DryTAG RH on the grill as shown. Thread zip ties through the slots in the DryTAG RH. Pull each end of the zip ties through the holes in the grill.
- Page 4 DRYTAG RH MOUNTING INSTRUCTIONS Mounting DryTAG RH on a Phoenix R250 STEP MOUNTING INSTRUCTIONS Using a side cutter, trim off excess. Re-install grill onto unit. Re-install screws. Re-install lay-flat duct ring.
- Page 5 DRYTAG RH MOUNTING INSTRUCTIONS Mounting DryTAG RH on a Phoenix R250 STEP MOUNTING INSTRUCTIONS Install complete. USEPHOENIX.COM 800-533-7533...
Need help?
Do you have a question about the DryTAG RH and is the answer not in the manual?
Questions and answers