Advertisement
DryTAG RH Temp/RH Sensor
SETUP
Thank you for purchasing a Phoenix DryTAG RH Bluetooth Beacon. Please follow
these steps to successfully locate your DryTAG RH, add it to a piece of equipment
and add that equipment to your inventory in the DryLINK
information on DryLINK and the entire Ecosystem,
visit www.usephoenix.com/phoenix-drylink-mobile-app/.
USEPHOENIX.COM | 800-533-7533
QUICK START GUIDE
Pull out the battery tab to
activate the battery
Mobile App. For a more
®
Scan QR code
for more
information on
DryLINK
Tighten the screws if
needed
TS-1188 08/20 Rev A
®
Advertisement
Table of Contents
Related Manuals for Phoenix DryTAG RH
Summary of Contents for Phoenix DryTAG RH
- Page 1 Thank you for purchasing a Phoenix DryTAG RH Bluetooth Beacon. Please follow Scan QR code for more these steps to successfully locate your DryTAG RH, add it to a piece of equipment information on and add that equipment to your inventory in the DryLINK Mobile App.
- Page 2 DryTAG RH Temp/RH Sensor QUICK START GUIDE The DryTAG RH can be permanently attached to the outlet of a dehumidifier or used as a standalone thermo-hygrometer to automate the readings for an affected area, unaffected area, or HVAC. If you choose to mount the DryTAG RH on a dehumidifier, please see our mounthing instruction before continuing.
- Page 3 QUICK START GUIDE After clicking “Add New If you select a Equipment” either dehumidifier to add the select dehumidifier or DryTAG RH to, you will meter and fill in the see this screen. Click information. “OK.” After clicking “OK” it...
- Page 4 RH. Delete it from your inventory. If you do not click “Remove DryTAG” first, it will remember the original association and not allow you to change it. Additionally, the DryTAG RH may take up to 15 minutes to pop up the blue box allowing you to add the unit again.
Need help?
Do you have a question about the DryTAG RH and is the answer not in the manual?
Questions and answers