Table of Contents
Advertisement
4
Press the ... or † button to select the
Antenna connection, then press the ENTER
button.
• Air : "Air" antenna signal
Cable : "Cable" antenna signal
Air+Cable : "Air" and "Cable"
antenna signals
• If the CableCARD is inserted into the
"CableCARD" slot on the rear panel,
"Cable" and "Air+Cable" are not
available.
When selecting Cable TV system:
Press the ... or † button to select "Cable",
then press the ENTER button.
Press the ... or † button to select "STD",
"HRC" or "IRC" then press the ENTER
button.
• STD, HRC and IRC identify various
types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing
Channels in Memory".
5
Press the √ button to select "Start" button,
then press the ENTER button to start the
auto program. The TV begins memorizing
all available stations. Press the ENTER
button at any time to interrupt the
memorization process.
Press the EXIT button to exit.
• The TV MUST be connected to an
antenna in order to receive digital TV
signals. Even if a particular channel is
deleted from the memory, you can
always tune to that channel directly
by using the number buttons on the
remote control.
Auto Program
Input
Select the antennas to memorize
Picture
Start
Air
Sound
Cable
Start
Channel
Air+Cable
Start
Setup
Guide
Move
Enter
Return
Auto Program
Select the cable system.
Input
Analog
Picture
STD
Start
✔
HRC
Sound
IRC
Digital
Channel
✔
STD
Setup
HRC
IRC
Guide
Move
Enter
Return
Auto Program
Select the cable system.
Input
Analog
✔
Picture
STD
Start
HRC
Sound
IRC
Digital
Channel
✔
STD
Setup
HRC
IRC
Guide
Move
Enter
Return
Auto Program
Auto Program in progress
Air Channel 44
Stop
Enter
Return
English - 35
Advertisement
Table of Contents
