Related Manuals for Lennox G60DF Series
Summary of Contents for Lennox G60DF Series
- Page 1 E 2003 Lennox Industries Inc. Dallas, Texas, USA 504,783M 6/2003 Supersedes 504,574M 06/03 504,783M *2P0603* *P504783M*...
- Page 2 NOTE - This manual must be left with the equipment user. Page 2...
- Page 3 Contact your Lennox dealer for an inspection by a quali or introduce these products into the combustion air. fied service technician. These products can cause furnace corrosion.
- Page 4 The gas valve on the G60DF(X) is equipped with either a gas control knob or lever. Use only your hand to turn the gas control knob or push the gas lever. Never use tools. If the knob or lever will not move by hand, do not try to repair it.
- Page 5 The blower motor is pre-lubricated for extended bear ing life. No further lubrication is needed. Call your Lennox service technician if the unit will not oper ate. Before calling, always check the following to be sure service is required.
- Page 6 (on the unit and in the room where the furnace is installed) - Must be open and unob structed to provide combustion air. - Must be inspected for rust, dirt, or signs of water. If you repeatedly hear any new or unfamiliar sounds - Must be inspected for signs of water, damaged while your unit is operating, there may be a problem.
- Page 7 The following repair parts are available through Lennox dealers. When ordering parts, include the complete furnace model number listed on the CSA International nameplate -- Example: G60DF(X)-36A-070-4. Upper access panel Flame Sensor Blower panel Heat exchanger assembly Top cap Gas manifold...
Need help?
Do you have a question about the G60DF Series and is the answer not in the manual?
Questions and answers