Bleeding the hydraulic system
Bleed the system by connecting a cylinder or tool to the
pump. Run the tool/cylinder through 3-4 cycles (pump to
full extension, then release) without any load. Make sure
that the tool/cylinder is positioned lower than the pump
to allow the air to return to the pump's oil reservoir.
Depending on the amount of air present in the connected
hoses or tools it may be necessary to top up with hydraulic
oil, see the heading Filling with oil.
Hydraulic equipment must be serviced and maintained
regularly to keep it in good working condition. For safety
reasons it is important that hydraulic products are serviced
and maintained by experienced personnel. If in any doubt, contact your
dealer for information about the nearest authorised service agent.
Always use original Simson spare parts. Lubricate moving
parts as necessary with a high quality grease. Always
use high quality hydraulic oil with good low temperature
properties, ISO VG 10 or equivalent.
Recycling
The various parts can be recyced at the end of their service
life. The unit consists of steel, aluminium, hydraulic
oil, rubber (seals) and plastic. Collect the hydraulic oil
and dispose of it separately. The unit does not contain
any pressurized components. For more information
about recycling of this product, please contact the local
authorities, your waste disposal service or your provider.
Guarantee
Simson Hydraulics AB provide a full guarantee covering
manufacturing and material faults. During its manufacture
the product has undergone several control checks
to ensure its safety, efficiency and quality.
The guarantee covers new products and is valid for 12
months from the day the customer receives the product.
Claims under the guarantee can be made only wiht original
receipt of purchase.
The guarantee is valid only if the product has been used
under normal operating conditions and according to the
instructions provided.
The guarantee does not cover, e.g.:
• damage caused by normal wear or lack of maintenance
• damage caused by misuse or overloading
• modification or rebuildning not approved by Simson
Hydraulics AB
• damage resulting from the use of spare parts which are not Simson origi
nal parts.
Simson's guarantee for electric and petrol engines supplied
together with the product is based upon the guarantee
terms of each manufacturer. These documents are enclosed
with the products concerned.
Claims under the guarantee should be made to your retailer
who will refer you to the nearest service workshop
for repairs or possible replacement.
Simson Hydraulics AB accept no responsibility in addition
to this.
Simson Power Tools AB
Nitvägen 3 , 813 33 Hofors, SWEDEN P.O. Box 68 813 22 Hofors
Tel: +46 (0) 290 23080 Fax: +46 (0) 290 24403 info@simsonpowertools.se www.simsonpowertools.com
Need help?
Do you have a question about the PH Series and is the answer not in the manual?