Download Print this page
RDT FloodMaster RS-094 Manual

RDT FloodMaster RS-094 Manual

Water heater / tank leak detection & automatic shut-off system

Advertisement

Quick Links

Water Heater / Tank Leak Detection &
Congratulations on your purchase of a FloodMaster RS-094 water heater leak detection system
from Reliance Detection Technologies. This product is designed to automatically shut off the
water supply to a water heater or tank if a leak is detected.
To ensure proper installation and to maximize the performance of your RS-094 water leak
detection system, please read this manual thoroughly before installing or operating the system.
PLEASE READ CAREFULLY BEFORE PROCEEDING:
If a leak is detected, the RS-094 will shut off the water going to the water heater. This will stop
the continuous flow of water from the water supply to the tank. However, all or some of the
water that is already in the tank may still leak out onto the floor.
NOTE: This installation and operating manual contains important information about the operation of the
RS-094 system. If this system is being installed for use by a different user, please be sure a copy of this
manual is left with the system for future reference.
www.RelianceDetection.com
RS-094 System Components (included in kit):
1 – Receiver box / actuator
1 – Full port lead-free shut-off valve
(NSF/ANSI 61 and 372)
1 – Power supply with 12' lead wire
RS-094
Automatic Shut-Off System
Toll-Free: 888-771-4929
1 – Water sensor with 8' lead wire
1 – Metal plate for sensor placement

Advertisement

loading

Summary of Contents for RDT FloodMaster RS-094

  • Page 1 Water Heater / Tank Leak Detection & Automatic Shut-Off System Congratulations on your purchase of a FloodMaster RS-094 water heater leak detection system from Reliance Detection Technologies. This product is designed to automatically shut off the water supply to a water heater or tank if a leak is detected.
  • Page 2 NOTE: The RS-094 can be installed on existing or new water heater installations. RDT recommends that installations be completed by a licensed plumber to ensure that all local code requirements are followed. INSTALLATION INSTRUCTIONS 1. Turn off the water supply feed line to the water heater.
  • Page 3 RS-094 1. Receiver box 6. Valve actuator 2. Valve Closed LED 7. Water sensor WATER 3. Power LED 8. Metal plate 4. Wiring terminal block 9. Shut-off valve HEATER KIT 5. Reset button 10. Power transformer FRONT VIEW BACK VIEW BOTTOM VIEW 1.350 Ø...
  • Page 4 OPERATION & SYSTEM RESET In the event the system activates, locate the source of the leak, remove the sensor from the water and dry the metal contacts on the bottom. Correct the problem causing the leak and replace the sensor in the desired leak detection location once again as required. Press and release the “Reset”...