Samsung HP-P4271 Manual page 2

¸ SRS TSXT button
Selects Trusurround XT mode.
˛ MTS button
Press to choose stereo, mono or Separate Audio Pro-
gram (SAP broadcast).
◊ AUTO PROG. button
The TV automatically cycles through all of the avail-
able channels and stores them in memory.
± ADD/DEL button
Press to add or delete channels in the TV's memory.
≠ DNIe button
Activates DNIe (Digital Natural Image engine).
– CAPTION button
Controls the caption decoder.
— SET button
Used during set up of this Samsung remote control,
so that it will work compatibly with other devices
(VCR, Cable Box, DVD)
÷ PIP control buttons
SIZE : Press to make the PIP window Large,
Small or Double.
SWAP : Exchanges the video signal that is
currently displayed on the main screen
with the signal in the PIP window.
CH , : Displays the available channels in
sequence. (These buttons change channels
in the PIP window only).
® VCR, DVD control buttons
Controls VCR tape or DVD disc functions: Stop,
Rewind, Play/Pause, Fast Forward.
∑ RESET button
If your remote control is not functioning properly, take
out the batteries and press the reset button for about
2~3 seconds. Re-insert the batteries and try using the
remote control again.
1
Slide the back cover
to open the battery
compartment of the
remote control.
Remote Control Operation Range.
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
from the left and right sides of the PDP's remote control receiver.
Installing the Batteries in Your Remote Control
2
Install two AAA size batter-
ies. Make sure to match the
"+" and "-" ends of the bat-
teries with the diagram
inside the compartment.
3
Slide the cover back into
place.