Advertisement
Refer to fig.2 for the following tests
4. antifreeze test
4.1.
Read the test procedure.
4.2.
For Propylene Glycol read the left side of centre scale. For Ethylene and OAT read the right side of centre scale.
5. windscreen washer test
5.1.
Read the test procedure.
5.2.
Refer to lower right hand scale (under the screen wash symbol). Note: Variations in formulation of windscreen washer fluids may
result in an average value for a variety of alcohol based anti-freeze mixtures, this test is therefore a guideline only.
6. battery fluid test
6.1.
Read the test procedure.
6.2.
Refer to scale under the battery symbol, which Indicates the density of the battery fluid in kg per litre and the ranges for
recharge, fair and Good.
7. urea/adblue test
7.1.
Read the test procedure.
7.2.
Refer to scale 'urea' which indicates the percentage of urea to distilled water in Adblu: 32.5% indicates the most desirable percentage
of urea in the solution.
8. maintenance
8.1.
Keep the unit clean. Protect eye lens, display lid and prism to prevent scratching.
9. calibration
9.1.
For best results an ambient temperature of 20°C for both refractometer and fluid being tested is recommended.
To test instrument accuracy, place distilled water on the prism and check that the LIGHT-DARK dividing line is level with the
9.2.
"WATERLINE". If the reading is incorrect remove the black rubber cover from the calibration point (6). Insert the small supplied
screwdriver into the hole in the calibration point. Turn the screwdriver whilst looking through the eyepiece until the waterline mark is on
the light-dark dividing line.
9.3.
After use and cleaning store in supplied foam lined and plastic case.
fig.2
enVironment protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, Kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7ar
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
VS0052.V2 | Issue:1 28/02/18
Advertisement
