Sealey SG139 Quick Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
Familiarise yourself with the application, limitations and potential hazards peculiar to the coating gun.
9
WARNING! disconnect the gun from the air supply before changing accessories, servicing or performing any maintenance.
‰
maintain the gun in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the gun clean for best and safest performance.
9
ensure that the compressed air system can supply the gun air consumption (10cfm).
9
Wear approved safety respiratory protection and safety eye goggles.
9
Remove ill-fitting clothing. Remove ties, watches, rings and other loose jewellery and tie back long hair.
9
locate the gun in a suitable work area. Keep area clean and tidy and free from unrelated materials and ensure that there is adequate
9
ventilation and lighting.
Keep children and unauthorised persons away from the work area.
9
When not in use, ensure that the air supply is turned off.
9
Avoid unintentional operation of the gun.
9
DO NOT point the gun at yourself, other persons or animals.
8
DO NOT direct air from the air hose at yourself, other persons or animals.
8
DO NOT carry the gun by the hose, or yank the hose from the air supply.
8
DO NOT use the gun for any purpose other than that for which it is designed.
8
DO NOT allow untrained persons to operate the gun.
8
DO NOT get the gun wet or use in damp or wet locations or in areas where there is condensation.
8
DO NOT operate the gun if any parts are missing or damaged as this may cause failure and/or personal injury.
8
When not in use, disconnect the gun from the air supply, clean thoroughly and store safely.
9
2. INTRODUCTION
Accepts most types of 1ltr coating tins.
3. SPECIFICATION
model no: ...............................................................SG139.V2
Recommended air pressure: ......................................... 90psi
Air consumption: .......................................................... 10cfm
Air inlet size:..............................................................1/4"BSP
4. PARTS lIST
Item Part No.
1 SG139.V2-01
2 SG139.V2-02
3 SG139.V2-03
4 SG139.V2-04
5 SG139.V2-05
6 SG139.V2-06
7 SG139.V2-07
© Jack Sealey limited
AIR OPERATED UNDER BODY COATING GUN
model no:
Wear Wear
protective a mask
gloves
Description Item
Suction Tube 8
nozzle 9
Screw Cap 10
nozzle 11
Gun Body 12
Trigger Stud 13
Stop Ring 14
SG139.V2
Wear
protective
clothing
Part No. Description
SG139.V2-08 Packing
SG139.V2-09 Valve Spindle
SG139.V2-10 o-Ring
SG139.V2-11 Air Valve Spring
SG139.V2-12 Packing Screw
SG139.V2-13 Air Screw
SG139.V2-14 Trigger
Original Language Version SG139.V2 |Issue:4 (H,F) 09/03/18