Safety Advice Attention In some countries approval is needed to set up a marquee/tent larger than 75 m2. It is your responsibility to comply with local rules and regulations and to ensure that the marquee/tent is assembled correctly. In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is safely secured and that the marquee/tent does not cause damage to others.
Page 3
Assembly Illustration For “User Friendly” assembly we have identi ed each individual component with our part code number as indicated in the part list. Please refer to the part code numbers and drawings to ensure problem free assembly.
Page 4
Part list for 8m series Titanium Qty(pcs.) Part No. Descrip on Curved roof tube(top) at two ends &tube size:1341mm Curved roof tube(top) in the middle &tube size:1341mm Straight roof tube at two ends & tube size:1790mm Straight roof tube in the middle & tube size:1790mm Curved roof tube(side) at two ends &...
Page 5
Part drawings for 8m series Titanium 21-05-2015...
Page 11
Illustration for installation and tensioning for both sides of the roof cover 8x9x3x5 used for this illustration Hint for tensioning front and rear folds. Put the ropes in the roof cover pocket through the rings and pull hard the ropes. At the same time tidy rumple on the fold gradually.
Page 13
Hint for tensioning cover to frame Both sides and top part of rear cover are tightened to the frame by rope. The bottom part of rear cover is fastened to the tensioning tube by rope. M14x30mm bolt with nut...
Need help?
Do you have a question about the ST03810 and is the answer not in the manual?
Questions and answers