Replacing the optical-drive interposer
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
Steps
1. Align the screw holes on the optical-drive interposer with the screw holes on the palm rest and keyboard assembly.
2. Replace the screws that secure the optical-drive interposer to the palm rest and keyboard assembly.
3. Connect the optical-drive interposer cable to the system board and the optical-drive interposer.
4. Insert the optical-drive interposer cable into the latch and press the latch down to secure the cable.
5. Close the latch that secures the optical-drive interposer cable to the system board.
6. Route the display cable through the routing guide and connect it to the system board.
Post-requisites
Steps
1. Replace the
base
cover.
2. Replace the
optical
drive.
28
Replacing the optical-drive interposer
computer. After working inside your computer, follow the instructions in
12
After working
www.dell.com/