Philips LIGHTOLIER IS-LLAH11 Manual page 2

SET SCREW
HEX KEY
FIG. 6
NSTRUCTIONS FOR INSTALLING REFLECTOR (FIG. 7, 8,, & 9)
1. Orient the REFLECTOR(Sold Separately) as shown in (FIG. 7), so that the
SNAP features are aligned with the slots located on the HOLDER.
2. Push and rotate REFLECTOR clockwise into the HOLDER until SNAP
FEATURES are secure within the designated slots. (FIG. 8)
3. Replace FRONT HOUSING by aligning bayonet tabs with the open slots on
the HEAT SINK, pushing it firmly into the HEAT SINK and twisting it
clockwise until the spring clips are fully engaged. (FIG. 9)
Note: Ensure both clips are fully engaged and that there is no interference with
the two spring clips located on the front face of the heat sink. If there is
interference loosen the clips and orient them correctly, so that they may
catch the front housing upon assembly.
INSTRUCTIONS FOR INSTALLING OPTIONAL ACCESSORIES
(FIG. 10 & 11).
1. Remove FRONT HOUSING by twisting counterclockwise to unlock from
HEAT SINK. (FIG. 10)
2. Place accessories into the FRONT HOUSING through the back as shown in
(FIG. 11).
3. Replace FRONT HOUSING by aligning bayonet tabs with the open slots on
the HEAT SINK, pushing it firmly into the HEAT SINK and twisting it
clockwise until the spring clips are fully engaged.
4. Accessories will be secured between the REFLECTOR HOLDER and the
ACCESSORY HOLDER, which will be pushed upwards, and with accessories
installed, may remain above the top edge of the FRONT HOUSING when
fully assembled.
Note: Luminaire accepts one accessory and a snoot, max. The use of two glass
lenses and a snoot or one louver, one glass lens and a snoot requires the
use of a double accessory holder (Sold Separately).
5. If double accessory holder is required, remove the single accessory holder by
loosening the three engaged snap clips, discard, and push the double accessory
holder straight into the FRONT HOUSING until holder is fully secure.
HEX CELL
LOUVER
SNOOT
© 2016 Philips Lighting Holding B.V. All rights reserved.
www.philips.com/luminaires
IS-LLAH11 951463 Rev B Feb-16 page 2 of 4
HORIZONTAL
ROTATION
VERTICAL
ROTATION
FIG. 11
IS-LLAH11
ALCYON LED
HORIZONTAL
TRACK LIGHTING
LIGHTOLIER ADAPTER
INSTRUCTIONS FOR OPERATING LUMINAIRE.
1. Adjust VERTICAL and HORIZONTAL aim (FIG. 6).
Note: vertical and horizontal rotation have mechanical stops
and locking feature. Do not force past stop. If aim is locked
loosen SET SCREWS.
Note: Horizontal and Vertical aiming can be locked.
To lock, tighten SET SCREWS with hex key (by others).
Do not overtighten screws. to unlock loosen SET SCREWS.
2. Turn power on to track circuit.
REFLECTOR
FIG. 7
HOLDER
HEAT SINK
SPRING CLIP
HEAT
SINK
FRONT
HOUSING
FIG. 10
SNAPS
DO NOT PINCH WIRES
WITH REFLECTOR
FIG. 8
SPRING CLIP
FRONT
HOUSING
FIG. 9