Advertisement
User Manual ST-2300
Product Code.: 20 2300 556
Working with the ST- - - - 2300
Working with the ST
Working with the ST
Working with the ST
Operate the spray gun only within the pressure, flow rate and temperature ranges indicated. Prior to commencement of
work check the levels each time at the high pressure generator and adjust these if necessary. After familiarising yourself
with the safety instructions operating the spray gun is fairly simple:
▪ To operate the spray gun, retract the safety lock.
▪ Operate the trigger to open the spray gun.
▪ Release the trigger to close the spray gun. The spray gun is still under pressure.
▪ To prevent accidental activation of the spray gun move the safety lock up.
▪ Do not leave the spray gun unattended with the high pressure generator switched on.
▪ Rotating swivel joint (optional): So that the high pressure hose cannot be turned so as to unscrew the connection
between high pressure hose and spray gun a swivel joint may be used. By means of this swivel joint the gun may be
turned slightly when in an unpressured state in relation to the hose. With increasing pressure the swivel joint
becomes increasingly difficult to turn.
▪ If you change the fluid, also rinse the system between changes thoroughly with water.
▪ Move the safety lock up in order to secure the spray gun against accidental activation.
Cleaning
Cleaning
Cleaning
Cleaning
▪ Clean the unit prior to lengthy non-working intervals. If you have been working with detergents, operate the spray
gun and rinse it clear with water for 20 seconds.
▪ Operate the gun briefly in order to depressurise it. The pressure generator must be switched off during this
operation.
▪ If using the gun with detergent or disinfectants, rinse the gun thoroughly with water before lengthy work interruptions
(over 1 hour).
▪ Only use a fibre-free cleaning cloth for cleaning the exterior.
▪ Do not use any powerful detergents.
▪ Rinse clear.
Assembly
Assembly
Assembly
Assembly
Assembly, repair and maintenance work may only be carried out by persons trained in repair and maintenance work on
high pressure systems. Use only spare parts approved by Suttner GmbH. Only use high-pressure components (hoses,
connectors etc.) approved for the respective pressure and temperature range.
In order to prevent blockages incorporate a fine (recommended 50μm) filter into the high pressure generator water
supply.
Suttner GmbH, Hauptstraße 15-17, 33818 Leopoldshöhe
Tel.: +49(0)5208 - 91 46 - 0, Fax: +49(0)5208 - 91 46 - 15
www.rm-suttner.com, Email: info@rm-suttner.com
2300
2300
2300
5
Ver. 1.0
Advertisement
