CyberPower CSB604 Quick Manual

6-Outlet Surge Protector 6-Outlet Surge Protector
CSB604/CSB606/CSB606W CSB604/CSB606/CSB606W
USER MANUAL
Copyright © 2018 Cyber Power Systems (USA), Inc. All rights reserved.
CONGRATULATIONS ON YOUR PURCHASE
Thank you for selecting the CyberPower
CSB604/CSB606/CSB606W Surge Protector. This
manual explains the features and operation of the
CSB604/CSB606/CSB606W. Please take a few moments
to read this manual.
FEATURES
1. ON/OFF Reset Control Switch and Circuit Breaker
Controls power to all outlets. The switch is also a 15 A
breaker. When an overload occurs, it will automatically
switch o . To resume operation, ensure the overload
condition is removed and reset the surge protector by
switching the unit ON.
2. Six Standard Outlets
1
SURGE PROTECTOR INSTRUCTIONS
1. Set power switch into the "OFF" position. Plug the
surge protector into a standard grounding wall
receptacle by fully inserting the plug and ensure that
there are no exposed conductors.
2. Make sure electronic equipment is turned o before
plugging into the surge protector outlets. Do not use
extension cords to connect equipment to the
surge protector.
3. Set the power switch into the "RESET" position. The
surge protector will now be providing power and
surge protection.
4. Connected equipment can now be turned on.
SPECIFICATIONS
• Model Number: CSB604/CSB606/CSB606W
• Outlets: 6 Standard Outlets
2
• Surge Protection: 900 Joules
• Electrical Rating: 125 V/15 A/1875 W
• UL Clamping Voltage: UL 1449 3rd/500 V (H-N, H-G, N-G)
• 3 AC Lines Protected: H-N: 15,000 A, H-G: 15,000 A,
N-G: 15,000 A
• Response Time: Less than 1 nanosecond
• Attenuation: Up to 32 dB
• Circuit Breaker: Resettable 15 Amp
• EMI/RFI Filtration: 150 kHz to 100 MHz
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK - Use only
in dry locations and only indoors. DO NOT plug into
another relocatable power tap. DO NOT "daisy chain"
surge protectors. DO NOT use with any aquarium
equipment. DO NOT use if properly grounded outlets are
not available. DO NOT install this device if there is less
than 10 meters (30 feet) or more of wire between the
electrical outlet and electrical service panel. DO NOT use
for medical or life support equipment. This device
features an internal protection that will disconnect the
surge protective component at the end of its useful life,
but it will maintain unprotected power to the load.
TROUBLESHOOTING
▪
TECHNICAL SUPPORT
Please contact our Tech Support Department with
installation, troubleshooting, or general product questions.
• Phone: 1-877-297-6937
• Email: tech@cpsww.com
• Hours of Operation:
1
If the ON/OFF is switched OFF, the 15 Amp circuit
breaker may have tripped. Examine your connected
equipment and remove the device that is overloading the
circuit. Then, turn the ON/OFF switch back to RESET.
Monday – Friday 7:00am – 6:00pm CST
2