Baratza S913 How To Replace page 2

3. Next remove the bottom screw. This screw is more challenging to access. Start by using
the hex key. If you are unable to remove it with a hex key, you may need to use pliers to loosen
the screw and remove it.
4. Gently pry open each of the four clips holding the gearbox onto the motor mount. Put
opposing pressure on the gearbox to help pull it away from the motor. It is easiest to do this with
the motor clamped gently in a vise (wrap with a towel to avoid damage to the motor).
Because the bottom two clips are more difficult to access, it is easier to open those first:
APPLY PRESSURE TO CREATE GAP
www.baratza.com support@baratza.com rev. 10/23/2018