Description; Connection; Shaving; Changing The Shaving Parts - Braun 1008 User Manual

English
Our products are engineered to meet
the highest standards of quality, func-
tionality and design. We hope you
thoroughly enjoy your new Braun
appliance.
Important
Keep the shaver and the mains lead
dry at all times. Do not handle with
wet hands. Do not store in a damp
environment. To avoid damage do
not wind the mains lead around the
appliance. It is important to check the
mains lead for damage periodically
particularly at each end where the
mains lead enters the plug.

Description

1
Socket for the mains lead with
voltage selector
2
«on/off» switch
3
Longhair trimmer switch
4
Pop-out longhair trimmer
5
Cutter block
6
Shaving foil frame
7
Foil protection cap
8
Cleaning brush

Connection

115 V (110 V ... 120 V)
230 V (220 V ... 240 V)
Set the voltage correctly (115 V or
230 V) at the bottom of the shaver
(a). Only connect to ac (~).

Shaving

Remove the foil protection cap
Push «on/off» switch
Hold the shaver at right angles to your
skin. Stretch your skin with your free
hand (c). Guide the shaver smoothly
against the direction of beard growth,
applying only gentle pressure.
4
1
7
(b).
2
up to «on».
Longhair trimming
To use pop-out longhair trimmer
3
push switch all the way up to setting
«longhair trimmer».
The longhair trimmer allows easy and
exact trimming of the side burns (d).
The longhair trimmer can be switched
on and off during shaving.
Switching the shaver off
Push the «on/off» switch
the way to setting «off».
Important: After every shave replace
the foil protection cap
6
frame .
Cleaning and maintenance
After every shave, remove the foil
6
frame (e) and tap out lightly. Brush
out the cutter block
8
ing brush (f). Do not clean the
6
shaving foil with the cleaning
brush to avoid damaging it. Approxi-
mately every four weeks clean the
space between the longhair trimmer
4
and the shaver with the cleaning
8
brush .
Clean the cutter block
cleaning spray to maintain your
shaver's top shaving performance
and to keep it hygienic.
After every cleaning replace the foil
7
protection cap

Changing the shaving parts

The shaving foil frame
held at the two grooved surfaces and
pulled off (e).
The cutter block
(e.g. for cleaning) by turning it at right
angles to the shaver and lifting it off (g).
4
2
back all
7
on the foil
5
with the clean-
5
with Braun
on the foil frame
6
should be
5
can be removed
,
6
.