Hanna Instruments Edge HI2002 Instruction Manual page 21

Select the Manual (Stability) lot and press SETUP/CLR key. The
"CLEAR" message will be displayed along with "MANUAL" or
"STABILITY" and "CFM" tag blinking on the LCD. Press the GLP/CFM
key to confirm the deleting of the selected lot (MANUAL or STABILITY)
or all records. Press SETUP/CLR key to exit without deleting.
The lot number is used to identify particular sets of data. The lot numbers are allocated successively
until 100, even if some lots were deleted. The total number of lots that can be saved is 100. If
some are deleted (for example 1‑50), fifty additional logs may be stored. These will be numbered
101‑150. The lots are allocated successively (provided available memory space) until 999 is reached.
After this, it is necessary to delete all the LOT logs to start over the numbering.
Delete All
All pH logs, (or all ORP logs) may be deleted in a single clear. This function will delete all MANUAL,
STABILITY and INTERVAL logs.
Press the RCL key. pH will be blinking. Use RANGE/
desired measurement parameter log data to delete (pH or ORP).
While the measurement type is blinking and message states "LOG
RECALL", press SETUP/CLR key.
"CLEAR ALL" and measurement type will be displayed with "CFM" tag
blinking. Press GLP/CFM key.
"PLEASE WAIT" and the percent cleared will be displayed until
completed.
Note: If SETUP/CLR key is pressed in error, press SETUP/CLR
key again to exit without deleting.
key to select
u
21 21