Advertisement
Pedestal Base
•
Place the pedestal tube onto the base under the base add washer then tighten with the
screw provided.
Mounting Fan onto Pedestal Base
•
If necessary, slightly loosen the head securing screw by turning it anticlockwise.
•
Slide the switch box down over the inner tube and tighten the securing screw.
•
Make sure the securing screw is done up tightly.
Blade and Grill
•
Unscrew the guard mounting nut from the front of the motor housing by rotating it
anticlockwise.
•
Position the rear grill against the front of the motor housing with the handle at the top,
ensure that the locating pegs on the motor housing are engaged correctly in the holes of the
rear grill.
•
Tighten the guard mounting nut clockwise; do not to over tighten.
•
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the
drive pin that passes through the motor shaft.
•
Tighten the blade cap by turning it anticlockwise.
•
Place the front grill and install the plastic ring around the grills.
•
Tighten the screw on the bottom of the ring to lock in place.
Assembly
Advertisement
