Leenders Sorenne Installation Manual

Advertisement

Quick Links

SORENNE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sorenne and is the answer not in the manual?

Questions and answers

Summary of Contents for Leenders Sorenne

  • Page 1 SORENNE INSTALLATION EN...
  • Page 2 Points of attention installation Sorenne Required tools Transport • Remove the 2 bolts that secure the Sorenne to the pallet. • Remove the door: open the door and lift it off the hinges. • Take and transport with the hand truck at the front. Place protection between the hand truck and the Sorenne to prevent damage.
  • Page 3 SORENNE LEENDERS Fresh air supply (optional) • Place compriband under the base. • The compriband then expands. • Mount cover plate later. Level • Optionally set 4 feet. Swivelling base (optional) • Remove transport block (4x). 201951.000.I.EN...
  • Page 4 SORENNE LEENDERS Swivelling base (sequel) • If swivelling by 120°: place one of the screws of the transport block as shown in the drawing. Fresh air supply (sequel) • Place the cover plate. Place three of the screws of the transport block.
  • Page 5 Parts of the fire chamber can shift during transport. To prevent this, the heat shield and air pipes are secured with a small amount of silicone sealant. Check to see if these are still secured. Inspection Pay close attention to the following points after installing the Sorenne: • Check that the Sorenne stands securely on its base.
  • Page 6 General instructions and regulations Installation To secure the warranty, the Warne must be installed by a properly qualified person employed by a dealer recognized by Harrie Leenders Haardkachels. See leenders.nl for a current list of addresses of recognized dealers or contact the manufacturer.

Table of Contents