Rion DA-20 Instruction Manual page 91

The fi rst push of the [START/STOP] switch on the Remote Controller starts
recording. When the switch is pushed while recording is in progress, record-
ing stops. The operation status indicator provides the information listed in
the following table.
Status indicator
Flashing red
Flashing green
Lit red/flashing green
Lit red (1 second or more)
Off
When an overload condition continues, no distinction is made with regard
to whether it is before or after recording start. However, recording under
permanent overload conditions is a problem. Adjust the level range setting
to prevent overload.
Operation
Data recording in progress
Trigger standby
Overload occurred during trigger standby
Overload occurred
(before or after recording start)
Other condition
Preparations
79