Troubleshooting - Beaba 920328 Instructions Manual

7.Reset the "Replace Filter" light
If the "Replace Filter" light is still on, reset the sensor.
Press and hold the "Replace Filter" button for 3 seconds, the light goes out and reset is complete.
REPLACING THE FILTER IN ADVANCE
|If the purifier is used in a polluted environment, it is possible to replace the filter even if the "Replace
Filter" icon is not on.
To do this, follow the "Replacing the filter" instructions.
FORCING THE RESET OF THE FILTER'S LIFESPAN :
In sleep mode (do not press the "power" button), press and hold the "filter" button for 3 seconds, the
"filter" icon comes on. Press the "filter" button a second time for 3 seconds and the filter light goes
out. Reset is complete.
STORAGE
Unplug the cable, wipe the appliance so that it is clean and store it in its box in a room protected from
damp conditions.

TROUBLESHOOTING

This chapter summarises the problems most commonly encountered or which may potentially be
encountered with this appliance. If it is not possible to solve this problem using the information below,
contact the Beaba customer service.
Problem
The appliance does
not work
The flow of air is much
weaker than before
Low performance or
poor purification
After replacing the
filter, the "filter" icon
is still on
The purifier does not
remove odours from
the room
Potential cause
The plug is not connected.
The plastic bag around the filter has not
been removed
"Low" speed is activated
The filter has not been replaced
There is not enough space around the
purifier's ventilation in the room
The room's surface area exceeds the
capacity of the purifier
The air inlet or outlet is blocked
The reset of the filter's lifespan is incorrect
The air purifier eliminates odours in the air
only and not odours from any furniture or
furnishings present
Possible solution
Unplug it and plug it in again.
Unplug the appliance and remove the
plastic bag from the filter
See "Before using for the first time"
Press the "Speed" button to adjust the
speed level
Replace the old filter with a new filter
Check that there is 40 cm of space
around the purifier
Use the purifier in a room with the
appropriate surface area
Remove any objects in front of the air
inlet or outlet
Press the "Replace Filter" button for 3
seconds, the filter light goes out and
reset is complete.
Clean the furniture to remove any
odours from it