Table of Contents
Advertisement
[1] DC POWER SOCKET
13,8V DC power for the transceiver
is fed through this socket using
DC power cable suppiied,
[2] PA JACK
For connection of 8 ohm speaker for
PA operation,
[3] EXTERNAL SPEAKER JACK
The
impédance
speakers
connected
should be 8 to 16 ohms.
of a plug into this jack automatically
MOBILE INSTALLATION
TRANSCEIVER MOUNTING
Before installing the transceiver in a car,
truck, boat, etc., be sure to choose a
location which is convenient to the oper-
ating Controls and will not interfère with
the normal functions of the driver. The
transceiver may be mounted to the under-
side of the instrument panel of dashboard
of a car, truck, etc., by means of the
special bracket that is suppiied with the
transceiver.
of earphones
or
to
this jack
Insertion
silences the internal speaker.
[4] SELECTIVE CALL JACK
Optional sélective call unit plugs into
this jack.
Consult your dealer for
definite information. Do not remove
the plug covering this jack unless you
are using the sélective call unit.
[5] ANTENNA RECEPTACLE
For antenna lead-in cable [RG-58/U]
or [RG-8/U] with matching PL-259
type coaxial connector.
Attach the bracket to the underside of
the instrument panel or dashboard of the
vehicle
using the self-tapping screws
suppiied.
Then attach the transceiver to
the bracket by means of the two knurled
securing screws at the sides.
Tilt the unit upward or downward to the
desired angle before tightening the secur
ing screws.
5
Advertisement
Table of Contents
