Maintenance - Swann SK32020N Manual

6. Tip: You can also start the grinding or brewing procedure at any time before the set
starting time. To do this, press the Programme button once to switch off the timer and
then press the On/Off button to start the grinding or brewing procedure manually.
7. After the brewing procedure, you can take the coffee pot from the hotplate and serve the
coffee.
8. After the brewing procedure, the hotplate remains on for another two hours and then
switches off automatically.
9. If you would like to turn off the coffee machine before the two hours are up, press the On/
Off button
10. Clean the device after use (see the "Maintenance" chapter).
Always remove the mains plug from the mains socket before you clean the device or change
the water filter.
• The hotplate is very hot after use! Let it cool down first before cleaning it.
• Never immerse the device, the cable or the plug in water.
• Do not use corrosive or abrasive cleaning agents to clean the device. These could
damage the surface.
Cleaning the Device
1. Clean the coffee mill using the cleaning brush.
3. Then close the cover again by pressing down on the cover and adjusting the screw on
the opening for cleaning the coffee mill with the shaft end of the cleaning brush to the
"Closed" symbol
4. Then press the unlocking button on the side of the device and open the filter compart-
ment.
5. Take out the permanent filter and dispose of the coffee powder.
6. Clean the permanent lter and the filter compartment insert with hot water and a little
detergent if necessary.
7. Then dry all parts thoroughly and place them in the coffee machine again.
8. If necessary, clean the coffee machine and hotplate with a damp cloth and then with a dry
one.
7
SK32020N_IM.indd 7
HOW TO USE

MAINTENANCE

2. Adjust the screw at the opening for cleaning the cof-
fee mill with the shaft end of the cleaning brush to the
"Open" symbol
remove any excess coffee powder with the cleaning brush.
.
. The cover will open up and you can then
14/10/2014 07:58