Swann SK32020N Manual page 5

Bean to cup coffee maker
Table of Contents

Advertisement

PREPARATION & FIRST USE
Unpack the unit completely and remove any stickers that can prevent unit operation. Check the
unit for damage, do not use it in case of damage.
Do not immerse the coffee maker into water or other liquids.
Do not wash the unit in a dishwashing machine.
First Use
1.
Place the device on a level, firm and heat-resistant surface.
2.
Connect the device to a mains socket that has been properly installed.
3.
The preset time "12:00" will appear on the display.
4.
Set the time using the Hour and Minute buttons.
Brewing Coffee with Freshly Ground Beans
1.
Open the water reservoir cover.
2.
Fill the desired amount of water into the water reservoir. On the water level indication, you
can see how many cups of water you have already poured into the water reservoir.
3.
Always fill the water reservoir with at least two up to a maximum of 10 cups of water.
Then close the water reservoir cover.
4.
Open the filter compartment by pressing the unlocking button on the side of the device.
5.
Place the filter compartment insert and the permanent filter into the filter compartment.
Make sure that all parts are placed in correctly as otherwise the coffee machine will
not start the brewing procedure.
6.
Close the filter compartment.
7.
Fill coffee beans into the grinding mechanism of the coffee machine. Then place the lid of
the grinding mechanism back on.
8.
Place the coffee pot on the hotplate.
9.
Use the 2–10 cup button to set the number of cups you would like to brew.
10. You can press the Strength button to set the coffee strength. You have a choice of three
levels. One bean: mild, Two bean: medium, Three bean: strong
11. Press the On/Off button to switch on the device. The On/Off button lights up
12. As soon as you have pressed the On/Off button, the grinding procedure begins. After the
grinding procedure, the brewing procedure starts immediately
13. After the brewing procedure, you can take the coffee pot from the hotplate and serve the
coffee
14. After the brewing procedure, the hotplate remains on for another 40 minutes and then
switches off automatically.
15. If you would like to turn off the coffee machine before the two hours are up, press the On/
Off button
16. Clean the device after use (see the "Maintenance" chapter).
17. The coffee machine has a non-drip valve. You can also take the coffee pot from the hotplate
during the brewing procedure and pour yourself a cup of coffee. But be careful: You should
place the coffee pot back on the hotplate within 20 seconds to prevent the coffee filter
from overflowing with water!
SK32020N_IM.indd 5
HOW TO USE
5
14/10/2014 07:58

Advertisement

Table of Contents
loading

This manual is also suitable for:

5055322509644

Table of Contents